National Highway Traffic Safety Administration2016 Jeep WranglerEngine

While driving my Jeep Wrangler on the highway going speeds of >60 mph for longer than 20 minutes the vehicles check engine and traction control light illumin…

ODI Happened June 17, 2021Filed January 18, 2023

In the owner's words

While driving my Jeep Wrangler on the highway going speeds of >60 mph for longer than 20 minutes the vehicles check engine and traction control light illuminate and I lose passing capability in the Jeep. Once the vehicle is turned off and on 3 times the system seems to reset itself. Because of this the only way the dealership can read the codes is if the lights are illuminated. I have taken the Jeep to 2 different Jeep dealerships while the lights were on and both have claimed that the "system needed to be reset". Once they do that the Jeep seems to run fine and the lights are gone. However, it is still happening whenever my speed goes 60 mph or more for a short period of time. Due to this problem I am not comfortable but sometimes must take my Jeep on the highway and without fail the same warning lights illuminate and the passing power is gone. I have reported this problem to Jeep itself and was told to take it to another Jeep dealership which I did and the same maintenance was performed but yet the same problem exists. This failure is a hazard to not only the driver but those around due to the vehicles lack of passing power when on a highway where speeds are at a minimum of 65mph.

An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.