National Highway Traffic Safety Administration2000 Jeep WranglerStructure › Body, Suspension

Frame rotted from the inside out around the lower control arms

ODI Happened August 16, 2019Filed August 13, 2020

In the owner's words

Frame rotted from the inside out around the lower control arms. The chassis is otherwise rust free, but it spontaneously rotted from the inside out. The lower control arm disconnected while driving down the highway, leaving the rear axle free floating, unstable, and very likely to cause a crash. The frame has holes in it that let water in. There is no drainage hole where the frame goes from flat on the bottom and curves up around the wheel wells. Water gets into the frame, sits there, and rots it from the inside out. There is no way to see this rot from the outside and there is no way to fix it without cutting open the frame and welding in repairs. If you google image search "jeep tj frame rot" you can see other cases of the frame failing in the exact same location. Here's a blog post with several instances of it https://sarahstonesadie.blogspot.com/2019/05/jeep-tj-frame-recall.html if you google "tj frame cap" you'll see there's an entire sub market of products specifically made to address this failure. Toyota had a frame recall, why can't jeep? It's clearly failing in the exact same place and can cause severe safety issues. Attached is a picture "pre_rot" that showed it about 6 months(?) before it completely rotted through. The other picture is after it failed while driving down the highway. It was a small rust bubble that started from the inside out that fairly rapidly resulted in complete structural failure.

An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.