National Highway Traffic Safety Administration2008 Chevrolet CorvetteEngine, Brakes, Steering
I was concerned about excessive valve train noise and after reading several corvette forum threads about improperly machined heads by gm's supplier linamar,…
ODI Happened March 16, 2015Filed March 21, 2015
In the owner's words
I was concerned about excessive valve train noise and after reading several corvette forum threads about improperly machined heads by gm's supplier linamar, and that numerous vehicles have had valves drop and ruin the engines, loosing a valve while driving will result in loss of power assist for steering and breaking while on the road . I took my car with 13500 miles on it to a corvette specialty shop to have my valve guide clearance tested. I had (8) exhaust valve guide and (3) intake valve guides outside of service specifications, and a combination of (5) other intake valve guides at or near the maximum outside of service specifications. The car is being repaired with proper re-machining of the heads to make the valve guides concentric, new intake and exhaust valve guides installed, as well as new seals, valves, springs, etc. I can provide data on the failed guides for documentation 88% of the corvette forum members who have had their cylinder heads tested for excessive valve guide wear, were out of service specifications. Source: http://www.corvetteforum.com/forums/...-registry.html gm needs to issue a recall on this issue, there have been numerous engine failures as a result of a dropped valve into a cylinder which can cause accidents and fires. Gm is very aware of this issue, but refuses to do anything about this huge safety risk to drivers, passengers, and nearby vehicles if the engine fails going down the road. *tr
An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.