National Highway Traffic Safety Administration2003 Chevrolet Suburban 2500Brakes › Hydraulic service brakes

While driving my 2003 k2500 chevy suburban, another vehicle pulled out in front of me from a side street while I was traveling about 35 mph and I pressed the…

ODI Happened July 9, 2010Filed July 9, 2010

In the owner's words

While driving my 2003 k2500 chevy suburban, another vehicle pulled out in front of me from a side street while I was traveling about 35 mph and I pressed the brakes very hard - hard enough to lock up at least one wheel, but avoided an accident. I continued on, but just a few seconds later, I approached an intersection, and the brake pedal went to the floor, with very little braking power. I was able to get the vehicle stopped by pumping the brakes quickly and ran slightly into the busy intersection. I pulled into a parking lot to inspect whether I had damaged something. I decided to return home about 1/2 mile away and slowly drove home, with very little braking power. When I got home, I crawled under the vehicle to find brake fluid splattered and leaking all over the underside around the abs unit. The brake lines are extremely corroded, and I suspect one has blown out. The vehicle is in very good and well maintained condition otherwise, but the underside seems particularly rusty. If I were traveling more than the 30-35 mph I was, there would have been no way to stop the vehicle. A serious accident would have occurred. These are very common vehicles, if this is typical, a safety recall must be initiated. *tr

An owner's report to NHTSA. NHTSA reads every complaint to decide what to investigate; it doesn't verify them, and a complaint is not a recall.