On certain motorcycles, engine vibration may cause the bank angle sensor’s wiring to rub on the wiring harness joint connector. Continuous vibration between the bank angle sensor wiring and the wire harness joint connector could cause an open circuit, which could result in an engine stall while riding. An engine stall could lead to a loss of stability of the motorcycle, which could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will relocate the joint connector and replace the bank angle sensor.

2015600 · 2,792 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorised dealer · All 2014 honda vt750ca recalls

On certain motorcycles, the starter relay switch may have had sealant incorrectly applied during assembly. This could result in increased resistance across the main fuse, potentially interrupting battery voltage to the electrical system. An interruption of battery voltage to the electrical system could cause the engine to either not start or stall while driving. Increased resistance at the main fuse could also cause a fire, potentially resulting in injury and/or property damage. Correction: Dealers will inspect the starter relay switch, and replace if necessary.

2015300 · 8,019 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorised dealer · All 2015 honda vt750ca recalls

Certain motorcycles may have been assembled with an improperly manufactured fuel control valve diaphragm. As such, fuel leakage could occur which, in the presence of an ignition source, may result in a fire. Correction: Dealers will replace the fuel control valve diaphragm.

2008105 · 4,069 units in campaign · Transport Canada

Applies only if the manufacturer confirms your VIN · repair by an authorised dealer · All 2008 honda vt750ca recalls